The Keg King Dual Controller (MKII) features dual outlets so you can control both a cooling unit and electric heater at the same time. The separate heat and cool outlets are located on the back of the unit.
As an example, get a chest freezer or refrigerator, and put a small space heater inside the refrigerator. Plug both the Space Heater and Refrigerator in the Heat and Cool plugs on the back of the control, and set the temperature for 55° F. The Keg King Controller will turn on the refrigerator when the temperature gets warmer than 55° and then turn on the Space heater if the temperature drops below 53° or so (depending on the delay you have programmed in). Many things can be controlled, such as wine cellars, fermentation chambers, mash temperatures, green houses, incubation chambers, your imagination is the limit.
It can also be programmed to step temperature up or down over a period of time (up to 12 separate steps). For optimum fermentation conditions using a chest freezer or refrigerator you can program the Keg King to start fermenting at one temperature, increase the temperature after a number of days and then crash chill. This is done without any intervention at all. Just program the control and forget.
You can also use this to increase the temperature of your electric mash tun so it will automatically step the temperature up and down as you please during a time period your specify.
Distillation mode is included, which means it will only heat cycle the unit once. What this means is if you set the temperature to 175° F., it will heat until it reaches 175° and then turn off, sounding an alarm to let you know the heat has been turned off. This can be handy with electric distillation and other uses when constant monitoring is not needed.
Other features include an adjustable differential, adjustable delay between the start of cooling and heating, or between the start of heating and cooling, cooling start delay, Centigrade and Fahrenheit modes, and adjustable high and low temperature alarms.
All features are accessed through programming; see the instruction pdf for details.
Includes a 6’ waterproof probe cord with stainless probe tip, and a 4’ power cord. The stainless probe is exactly 1/4" in outer diameter. Works from -49°F up to 248°F, and features a 10 amp cooling relay, and 13 amp separate heating relay so it can handle the load of any 110 volt electric heater.
A common question we get is how to set the Dual Controller to Fahrenheit. To do this, follow the steps below:
1. First hold the lower right set key down for about 6 seconds until it flashes E3.
2. Then press the lower right set key 9 times to get to C1.
3. Then press the upper left arrow button once to change the display to 01.
4. You will see 01 displaying for a few seconds and then it will return to display the temperature in Fahrenheit.
Dual heat and cool temperature controller -
Includes a 6’ waterproof probe cord with stainless probe tip - The stainless probe is exactly 1/4" in outer diameter
4’ power cord
Works from -49°F up to 248°F
Features a 10 amp cooling relay
13 amp separate heating relay so it can handle the load of any 110 volt electric heater.