Your shopping cart is empty!
STAR SAN SANITIZER
Use 2 tablespoons per 5 gallons of water, soak for 5 minutes. A foaming acid anionic sanitizer that penetrates hard-to-see places. No rinse. Does not stain and will not impart odors or off flavors.
STAR SAN HB is a blend of phosphoric acid and dodecylbenzenesulfonic acid. This synergistic blend provides a unique synergistic system that is unaffected by excessive organic soils. STAR SAN HB is also a self-foaming acid anionic detergent. It can be applied through a foamer to produce self-adhering foam or manual application. Cleaning with STAR SAN HB on a daily basis will leave equipment in an acid condition that will eliminate water spotting, mineral build-up, and corrosion. It is not recommended to use STAR SAN HB on soft metals because of the acid nature of this product.
GENERAL USE DIRECTIONS Brewing Tanks – Once the equipment has been properly cleaned make up a final acid anionic rinse using STAR SAN HB as follows: In every barrel of water add 7 fluid ounces, circulate for a minimum of 3 minutes at ambient temperatures. Just prior to start-up rinse with potable water and follow state and local Health Department regulations covering start up sanitation.
Part Soaking- In a 5 gallon bucket add 4 gallons of water and 2 ounces of STARSAN HB. Once all parts have been removed from equipment and hand washed allow them to soak in the STARSAN HB solution for a minimum of 5 minutes. Remove parts from solution. Reassemble wet parts on equipment to reduce the possibility of water spotting or any other undesirable conditions to occur, rinse equipment with potable water. Follow State and Local Health Department Regulations covering start up sanitation.
0 reviews / Write a review